0
What else can I help you with?
What is the main of flame trap?
A device that prevents a gas flame from entering the supply pipe.A device that prevents a gas flame from entering the supply pipe.
Pipe plugs on a harley?
Pipe Plugs????? are you trying to make a flame thrower?
How do you get bowsers fire back in Mario and luigi bowsers inside story?
first unlock the flame pipe area in bowser body then battle the boss that is covering the flame pipe
What is pipe clay?
A pipe clay triangle is used to support e.g. a crucible on a tripod over a bunsen flame.
What do you do after the flame pipe in Mario and Luigi Bowsers inside story?
bowser can breath fire!
Were is bowsers flame pipe on Mario and luigi bowsers inside story?
You have to complete the pumpworks level
Can styrofoam hot water copper pipe cover ingnite without a flame?
I've never heard of that happening.
How can a tobacco and a marijuana pipe be used?
Load pipe with marijuana not tobacco much better for you then on the side should be a carb hold thumb over it while holding flame to marijuana and inhaling. Then release thumb from carb and remove flame however, continue to inhale and that's all you do to get high my man
Where is the pipe?
I'm guessing you're referring to Mario & Luigi: Bowser's Inside Story. The 'Flame Pipe' area is on the center-right area of the map, north-east from Toad Square.
How do you get bowser's fire back in Mario an luigi bowsers inside story?
You have to defeat a bug that's blocking Bowser's flame pipe.
Where is the bug that's blocking Bowser's flame in Mario anLuigi Bowsers inside story?
Where is the bug? Clogging the Flame Pipe area. How to get there? Enter the DNA-door. Where is the door? Near the Pump Works area. How to enter the door? Ask Emoglobin.
What am I doing wrong when I can't get the solder to stick when soldering a copper pipe?
Not cleaning the pipe or joint enough, not using flux, or not heating the pipe or joint enough. You use the blue tip of the flame on the joint and the capillary action sucks the solder into the joint. You have to clean the pipe with sandpaper or steel wool, the joints with a fitting brush on the inside, and use a proper flux and solder.
