The Montero was made by Mitsubishi
Yes, a 90 hp Mercury outboard motor typically has a fuel filter rather than a traditional air filter, as outboard motors use water for cooling and rely on a fuel-air mixture for combustion. The fuel filter helps to remove impurities from the fuel before it enters the engine. It's important to regularly check and replace the fuel filter to ensure optimal performance. Always refer to the owner's manual for specific maintenance guidelines.
under the hood attached to the fire wall on the drivers side. the male fitting on the filter is bent @ a 90 degree angle facing the front of your car. it is same location for 1991 also
On a 1990 Mercury Sable : The ELECTRIC fuel pump is INSIDE the fuel tank ( it is installed through an access hole in the top of the fuel tank )
In front of the left rear tire.
on the 90's neons they dont have fuel filters htey have fuel pressure regualtors which you can diy.
The fuel filter is located on the fire wall just left of center. You can tell it is because it has the fuel line going into the top then one coming out of the bottom.
50 to 1 ratio
as to fuel, probably a pump or filter as to fire, could be the coil or distributer cap
check fuel filter and pressure
I was informed that the fuel filter shoulf be changed between 90 000km - 100 000km. The fuel filter is situated in the petrol tank and will only need to be changed every 80 000-100 000 km and not with every service...
Depends on the year. Most mid/late 90's Ram Trucks have a non servicable fuel filter. It is part of the fuel pump which is inside the gastank.
To replace the fuel filter on a 1990 Chevy Beretta, first, relieve the fuel system pressure by removing the fuel pump fuse and running the engine until it stalls. Next, locate the fuel filter, which is usually situated along the fuel line underneath the car. Disconnect the fuel lines from the filter using a line wrench, then remove the filter from its bracket. Install the new filter in the same orientation as the old one, reconnect the fuel lines, and finally restore the fuel pump fuse before starting the engine to check for leaks.