Ron,for this operation you will need a 20 mm wrench and a 16 mm wrench. You could get by with using 2 crescent wrenchs but I would not recommend doing so. Crawl under your vehicle on the driver's side under the driver's side rear door and look on the inside of the frame rail. you should see it there. use the 20 mm wrench on the filter itself and the 16 mm wrench on the fuel line. BE CAREFUL!!!! the line is pressurized so open it slowly and be sure to wear safety glasses and cover your mouth...or pull fuse for fuel pump and run the engine on idle until it stalls to remove remaining gas and pressure from the line Good luck.AnswerUnder the truck attached to drivers side frame rail, just forward of drivers seat. You will need a couple open end wrenches. Don't forget to pull fuse for fuel pump and run the engine on idle until it stalls to remove remaining gas and pressure from the line, make sure ignition is off and prepare for gas to spill in your face if you are anywhere underneath it and forget any of the above steps.
How do you get 1000000 robux for free?
What's the most outdated thing you still use today?
If you are 13 years old when were you born?
What is Spider-Mans phone number?
How many children did Alexander Hamilton have?
Why did Aaron Burr shoot and kill Alexander Hamilton?
Which city produces the most breakfast cereal?
How many times does 8 go into 75?
What is modal fabric??
What were George Washingtons false teeth made from?
Who was Yale University named after?
What determines whether you are left or right handed?
What would you do if the internet was suddenly gone?
What is the longest plate appearance in MLB history?
What is the official name of the Statue of Liberty?
Why can't we remember our dreams?
What are the advantages of turnaround document?
What are advantages and disadvantages of micro planning?
How does a miptor exercise?
Is Randy Fenoli married to Liza Menelli or is Michael Landry his partner?
Are the friction losses of an induction machine linear?
BA-28 which is a recommended water-skiing safety practice?
Are friction losses of the machine linear?
Which three square numbers that add up to 125?