So your fuel filter is going to be located if your facing your engine from the front, your north west side, looks like a cylinder with two nozzles connected to hoses on top and below it. what you wanna do is just unbolt the casing to the filter, use pliers to pinch those clamps and pull them over the hose, so u can connect them back later. Pull those hoses off, blow gas through the bottom end, if its plugged it will be hard to blow on it. Gas will just fly out if its not plugged. SO just throw your new filter in place and put the hoses back on to the fittings on the fuel filter. rebolt it back in place. wham bam thank you maam.
in the gas tank ?
it should be near the gas tank above the fram rail
behind the radiator,in the middle of the engine
-
The map sensor is on the air intake line to the throttle body....
The torque specs for the cylinder head on a b2200 are 59-64 ft lbs (cold).
yes you can its a straight swap you don't even have to change engine mounts
Was built with R12Was built with R12
Inside the blower motor housing directly behind the electrical coupler.
All the 1986-1993 mazda b series trucks were manufactured in japan.By the way great built trucks for that matter.
i own a 1990 fuel injected b2200 they didn't make very many but some of the 90-93 are injected.. finding parts are expensive and used parts for the motor are impossible to find
Not really. Technically you can probably make it fit with some mods but the 1994+ Mazda B3000 is actually a Ford Ranger body and frame.