You will need to jack up the RR corner of the vehicle to reach it. The fuel filter is fastened with a big clamp to the right side frame rail, close to the fuel tank, just ahead of the RR wheel. Use a small flat screwdriver to remove the two plastic clips from the lines attached to the filter. Be careful, the lines are under pressure, and there will be fuel that will spray out as you unplug the lines from the filter. Use a flat screwdriver to loosen the clamo from the body of the filter and then you can remove and replace the filter. Install the new plastic line clips that are in the box with the filter into the lines and then plug the lines onto the filter until you hear them click in place.
On a 1990 Mercury Sable : The ELECTRIC fuel pump is INSIDE the fuel tank ( it is installed through an access hole in the top of the fuel tank )
How can remove the rear seat on a 1990 mercury sable
Yes
According to my Chilton's Auto Repair Manual : For a 1990 Mercury Sable : ( 16.0 U.S. gallons or the optional extended range tank which is 18.6 )
Hey Clarissa==Try MOTORLIT.COM GoodluckJoe
In the relay block with the other relays.
Where is the fuel filter located on a 1990 chevrolet blazer?
The fuel filter is located near the rear of the vehicle, forward of the fuel tank.
Yes, but you'll have to pull the plenum first.
Your Ford/Mercury dealer can get the code. See "Related Questions" below for instructions on changing the lock cylinder
The fuel filter is located behind the fuel tank.
where is the fuel filter located on a 1990 ford ranger 2.3 L engine