0
Is there an easy way to change spark plugs on a 3.8 1990 mercury sable?
Wiki User
∙ 16y ago
Yes, but you'll have to pull the plenum first.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How many spark plug does Mercury Sable needs?
A V6 engine in a Mercury Sable takes ( 6 spark plugs )
How many spark plugs is there in a 1997 mercury sable?
A 1997 Mercury Sable has ( 6 ) spark plugs There were two 3.0 L V6 engines offered , the " Vulcan " and the " Duratec "
How to replace spark plugs on Mercury Mountaineer?
how to change spark plugs on a 97 mercury mountaineer
Is there an easy way to change spark plugs on a Mercury Sable Duratec 24 valve engine?
The only way to change the plugs is to remove the top cover first. Then remove the cover for each plug.
Where are the 1 2 3 spark plugs in a Mercury Sable?
In a Mercury Sable V6 : firewall 1-----2-----3 4-----5-----6 front of vehicle > driver
Where are spark plugs located on a Mercury Sable?
They are located in the cylinder heads. Just follow the wires and that will lead you to them
How do you replace spark plugs 1998 mercury sable v6 dohc?
Pull off the upper intake plenum and you will have access to the plugs and wires.
What is the spark plug gap on a 2005 mercury sable 3.0?
spark plug gap on 2005 mercury sable 3.0 =========================================================== Check the Vehicle Emissions Control Information ( VECI ) decal located in the front of the engine compartment ( it will show what type of spark plugs to use and the spark plug gap )
Change spark plugs for 99 Mercury Cougar?
BuRN
What is the correct spark plug gap for a 1992 Mercury Sable LS Wagon?
According to one of Fords websites : For a 1992 Mercury Sable : The 3.8 liter V6 engine has spark plugs gapped at ( .054 inch ) The website does not show the 3.0 spark plug gap
What should a tune up cost for a 2002 Mercury Sable?
Just had the spark plugs and wires replaced in my 2002 Sable and it cost $420+ tax. Hope this helps
Is it difficult to change the heads where the spark plugs attach on a mercury sable?
If you're talking about the cylinder heads, it's huge job. Way beyond the skills and tools of an amateur do it yourselfer
