0
Where is the fuel filter located on a 2001 Chrysler Town and Country Limited van with a 3.8 Liter engine?
Wiki User
∙ 13y ago
Its pretty easy: I have a 2001 town and country LXi 3.8L FWD. Your best bet is to nearly empty the tank. Raise the passenger rear side and remove both pass-side tank bracket bolts ONLY. The tank will drop about 5 inches. remove the front connector first. have a rag ready for some spill (this will free the pressure) then remove the screw that hold the filter in place. Remove the ground metal strap and DON'T loose it. Then remove the 2 connections to the gas tank. some leak may occur. Do not change the snap holders if not necesary. Make sure that the new filter does not have the snap holders (if it does, you may replace them if needed or just take them out) Snap the 2 connectors to the gas tank and make sure that the snap holders have snapped and that both catchers are properly snapped into place. Then screw the filter into its bracket. Dont forget the ground metal strap. lastly, connect the front connector and dont forget to keep the hard plastic hose cover right behind the tank bracket (keeps the hose from rubbing against the bracket and cracking). Last, screw the tank brackets back into place and dry all spliss BEFORE starting the van.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Where is the fuel filter located on a 2001 Chrysler Town and Country Limited van with a 3.3 Liter engine?
It is above and on the inboard side of the fuel tank.
Where is the starter located on a 2003 Chrysler Sebring convertible limited?
It is behind the engine mount on the radiator side of the engine.
Were is the catalytic converter on a 2001 Chrysler town and country limited edition?
In the exhaust pipe, at the back of the engine.
Where is the radiator thermostat located in a 1997 Chrysler Town and Country van?
The thermostat on a 1997 Chrysler Town and Country is located under the housing where the upper radiator hose attaches to the engine.
Where is the thermostat located on a 2006 Chrysler Town and Country?
The thermostat on a 2006 Chrysler Town and Country is under the housing where the upper radiator hose attaches to the engine.
Where is oxygen sensor located on a 1996 Chrysler Town and Country?
A 1996 Chrysler Town and Country has two oxygen sensors. They are screwed into the exhaust on the rear of the engine.
Where are the oxygen sensors located in a 1996 Chrysler Town and Country?
The oxygen sensors on a 1996 Chrysler Town and Country are screwed into the exhaust system behind the engine.
Where is the fuel pump on a 1999 Chrysler Town and Country Limited van with a 3.8 Liter engine?
It is in the fuel tank.
What size engine does the 2007 Chrysler Town-AND-Country have?
The 2007 Chrysler Town-AND-Country has a V6 engine.
What size engine does the 2011 Chrysler Town-AND-Country have?
The 2011 Chrysler Town-AND-Country has a V6 engine.
What size engine does the 2013 Chrysler Town-AND-Country have?
The 2013 Chrysler Town-AND-Country has a V6 engine.
What size engine does the 2006 Chrysler Town-AND-Country have?
The 2006 Chrysler Town-AND-Country has a V6 engine.
