If you look at the fuel rail. The rail that has the injectors connected to it. Some where on it (usually on the front side of the engine) there should be a port that should have a plastic cap covering it. Remove this cap and then you can attach a fuel pressure gauge or whatever to it. Good luck.
The automatics use different shift controls and are not interchangeable.
no
The typical fuel pump pressure for a 1997 Chevrolet CK 1500 truck is 50 psi. The high pressure is required to atomize the fuel when it leaves the injectors.
Back of the engine, next to the distributor
Group 27Group 27
on my 4x4 it is on top of the rear diff into the housing..
I bought a 1997 dodge ram 1500 larmie and the seller lost the keyless enrty. who do i get a new keyless entry? will i have to reprogram/replace anything on the truck
need to make sure power is getting to the brake light switch and abs unit
1997 dodge ram 1500 2wd 1500 engine block heater location
Follow the upper radiator hose to the engine. It is under the housing that the hose hooks to.
it sounds most likely to be an electrical problem.
It is on th eback of the engine , next to the distributor.