Passenger side floor, up under dash to the right of the driveshaft hump. Inertia switch is under the carpeting. Just push button down on top of switch to reset..
Owner's manual.My reset button is located on the passenger side, kick panel. (1988 XL areostar)
No, Dodge does not use reset switches.
It's under the panel with two screws in it on the dash, between the speaker covers. There will be 2 more screws that hold the box in there, and the reset button should be white with a red light next to it.
try to disconnect battery for 30 seconds
No.
The fuel pump is located in the tank if it is a TBI (EFI) Engine. And Dodge does not use inertia/reset switches.
Where is fuel filter on 1988 bronco II?" HOW TO CHANGE IT ---- It is located underneath the car, driver side area.
No
Check
There is none.
Dodge does not use inertia/reset switches.
The vehicle speed sensor is located at the rear differential on a 1998 Bronco II. This also serves as the ABS sensor.Ê