answersLogoWhite

0

The fuel tank pressure sensor is actually the fuel pressure regulator. There is a sensing unit within the regulator.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is the fuel pressure sensor on a 2003 Pontiac Aztek?

On the fuel tank.


How to replace fuel tank pressure sensor?

how to replace fuel tank pressure sensor pontiac gran prix 1997


Where is oil pressure sender for 1995 Pontiac transport?

Oil pressure sender /fuel pump switch for 1995 Pontiac transport 3.1 is located between oil filter and starter at front of engine.


What is the recommended fuel pressure of a 1995 Pontiac transport with a 3.1 engine?

The 1995 Pontiac 3.1 liter engine recommended fuel pressure is 17 pounds per square inch. The fuel pressure can vary a pound or two, and still be acceptable.


How do you replace a fuel tank pressure sensor on a 2003 Pontiac grand am?

To replace the fuel tank pressure sensor on a 2003 Pontiac Grand Am, first, relieve the fuel system pressure and disconnect the negative battery cable. Then, access the sensor by removing the fuel tank or, if possible, the access panel in the trunk. Disconnect the wiring harness from the sensor, unscrew it from the tank, and install the new sensor. Finally, reconnect the wiring, reassemble any components, and reattach the battery cable.


How do you change fuel tank pressure sensor in 2000 Pontiac Grand Prix GTP?

To change the fuel tank pressure sensor in a 2000 Pontiac Grand Prix GTP, start by relieving the fuel system pressure and disconnecting the negative battery cable. Next, remove the fuel tank by unbolting it and lowering it carefully, then locate the pressure sensor on the top of the tank. Disconnect the electrical connector and remove the sensor from its mounting. Install the new sensor, reconnect the electrical connector, and reassemble the fuel tank, ensuring all connections are secure before reconnecting the battery.


How do you check fuel pressure on 1998 Pontiac Transport?

To check the fuel pressure on a 1998 Pontiac Transport, you'll need a fuel pressure gauge. First, locate the fuel pressure test port on the fuel rail, then remove the cap from the port. Attach the gauge securely and turn the ignition to the "ON" position without starting the engine to read the pressure. The normal fuel pressure range for this vehicle is typically between 40-47 psi; if it's outside this range, further diagnosis may be needed.


Where is the fuel tank pressure sensor on a 1999 Pontiac Montana?

On a 1999 Pontiac Montana, the fuel tank pressure sensor is typically located on the top of the fuel tank, integrated into the fuel pump module. To access it, you may need to lower the fuel tank, as it is usually not accessible from above the vehicle. Always ensure to take proper safety precautions when working with fuel systems.


Where is the relay for a 1992 Pontiac transport?

Where is the fuel pump relay on a 1992 pontiac transport van


What should the fuel pressure be on a 1998 Pontiac transport?

The fuel pressure for a 1998 Pontiac Transport typically should be between 40 to 50 psi (pounds per square inch) when the engine is running. It's important to check this with a fuel pressure gauge to ensure proper fuel delivery and engine performance. If the pressure is outside this range, it may indicate issues with the fuel pump, filter, or pressure regulator. Always refer to the vehicle's service manual for specific diagnostics and specifications.


What does a fuel pump pressure sensor do?

The fuel pump pressure sensor monitors the fuel pressure of the vehicle.


Where is the fuel tank pressure sensor on a 2005 Pontiac Vibe?

It is attached to the top of the fuel pump assembly. It is the one with a three wire electrical plug.