answersLogoWhite

0

To replace the fuel tank pressure sensor on a 2003 Pontiac Grand Am, first, relieve the fuel system pressure and disconnect the negative battery cable. Then, access the sensor by removing the fuel tank or, if possible, the access panel in the trunk. Disconnect the wiring harness from the sensor, unscrew it from the tank, and install the new sensor. Finally, reconnect the wiring, reassemble any components, and reattach the battery cable.

User Avatar

AnswerBot

1w ago

What else can I help you with?

Related Questions

Where is the oil pressure sensor in 1999 Pontiac grand am?

Above the oil filter.


Where is oil pressure switch on a 2003 Pontiac grand am?

How to change oil pressure sensor on 3.4 sfi


How do you replace the speed sensor on a 2002 Pontiac Grand Am?

most likely you will have to replace the hub bearing assembly autozone for about $80


Replacing 1999 Pontiac Grand Am MAP sensor?

were is my 1999 pontiac grand am map sensor location


How do you replace the temperature sensor on a 2000 Pontiac Grand Prix?

Losen the exhaust cross over and take off temp sensor


How do you replace the cooling fan sensor in a 2001 Pontiac Grand Am?

Cooling fans won't stop running in the cold on a grand am gt 2001


How to replace the transmission sensor on a 2005 Dodge Grand Caravan?

where is the transmission fluid pressure sensor located o a 2005 dodge grand caravan


Where is the AIT sensor in a 1999 Pontiac Grand Am?

The 1999 Pontiac Grand Am AIT sensor is located on the outside of the air filter housing. The sensor will be on the back of the housing.


Cooling fan for rad on a 2000 Pontiac grand am will not turn on?

These fans work off of heat sensors. Your sensor can be failing, replace this sensor. This still does not tell where the sensor is located.


Where is the crankshaft sensor located on a 1996 Pontiac grand am with 2.4 motor?

were is the crankshaft sensor located on a 1987 Pontiac Grand AM with a 2.5L engine


Where is the throttle position sensor located on a 2004 Pontiac Grand Prix?

It is on the accelerator pedal. You have to replace the whole pedal assembly


How do you replace starter on 2.3cy 1991 Pontiac grand am?

How do you replace starter on2.3 cy 1991 pontiac grand am