The 1990 Chevy Lumina signal flasher unit can be found beneath the drivers side dashboard. The signal flasher unit will be above the brake pedal.
It will be called and instrument fuse. It will be located in the fuse panel under the dash, drivers side.
Yes, my uncle has a Chevy lumina and the headlights are always on,its andomatic
On the turn signal lever, pull back to dip or raise lights.
On my Chevy lumina it is located right by the gas take on the right side of the car.
The Chevy Lumina dashboard is held in place with retaining bolts and retaining clips. Remove the retaining bolts and pry outward on the retaining clips.
If you don't have dashboard lights, check the tail light. They often go out at the same time. Most U.S. manufacturers put them both on the same circuit so that we'll notice when the tail lights fail. Check the fuses first, if that's not it, start tracing back to the switch.
The Chevy lumina does not have an inertia switch.
In the 2000 Chevy Lumina it is on the driver's side of the dashboard, close to the windshield. It is a small hole. I would guess the design hadn't changed since '97, since it works so poorly in 2000, they obviously hadn't improved it any.
the regulator is getting bad in the alternator
This is likely to be a bad alternator or broken belt. This is common with GM cars, and it's happened to me more than once.
Possible bad stop light switch located near the brake pedal.