#7 or #23 on the inside fuse panel, back up is not labeled.
It is on the same circuit as the brake lights, but if they are not working, and the bulbs are good your switch needs cleaning or adjustment.
Attempt this first since the switch costs nearly $300 bucks.
On the passengers side of the trans just behind the bell housing there is a fan shaped switch, loosen the 12mm bolt ( smaller of the two, and rotate the switch while a friend checks the lights. this problem is usually accompanied by an occasional inability to start the vehicle, but can be cured by jiggling the shifter.
While adjusting the switch make sure that the vehicle will start in park as well, remember to block the wheels while testing the back up lights, engine off, key in run but not start, shifter in reverse, move switch until lights come on.
Once you find this spot, hold it in place and have your helper check to make sure it will start. This may take several tries to get both working correctly.
If you have no luck the switch may be dirty, this happens a lot. Hold the post to the bottom large bolt still while you loosen the nut, then remove it, then remove the 12mm adjusting bolt on top, remove the wire connector and pull the switch away, remove the bolts on the switch and separate the halves, use electrical contact cleaner and maybe some q-tips to clean all the copper connections completely apply di-electric grease and reassemble, refit to the trans and readjust so all functions work, this switch controls back up and start safety.
Caution! always hold that bottom bolt while tightening the large nut, this is connected to the gear adjuster and you could damage the internals if it isn't secured while you do it.
yes There was also a Laredo package for the XJ Cherokee in the 1990's.
The original tire size for a 1990 Jeep Cherokee Laredo is P195/75R15. The tires are for 15 inch wheels for the vehicle.
No.No.
It Is In The Gas Tank
my fuse panel (with the descriptions) is gone off of my 2000 jeep grand Cherokee Laredo, how to i get a description of what all 32 fuses control on my jeep?
Yes, Laredo is just a trim package.
try unscrewing the back light covers and replacing the lights
YES. The harness is behind the bumper in proximity of the location of the lights.
YES. The harness is behind the bumper in proximity of the location of the lights.
Jeep did not make a Cherokee Laredo, they did make a grand Cherokee Laredo, and you can fit 31 inch tires.
I mean how do you disassemble the fan blower in a 1998 Jeep Grand Cherokee Laredo. how do you remove the blower fan from the car in the Grand Jeep Cherokee Laredo.
No.