the 24 vac power source from the 24 vac transformer is protected by an automotive 3 amp fuse burried in the cable harness! The 3 amp fuse (pink) has two 1/4" quick connect lugs connected to the circuitry by two wires, a grey and green on my furnace, and was folded deep into the cable cluster held by a few cable ties. I expected a chassis mounted fuse, but nope! DO NOT USE A LARGER AMPERAGE FUSE than a pink 3 amp fuse. It protects the transformer from burning out if overloaded or shorted components, and something caused that fuse to blow--if blown! If it were blown, you would see a blackened spot in the fuse body between the two lugs.
My furnace and outside AC condenser unit were dead and I decided to troubleshoot it myself. The furnace schematic was pasted inside the control box cover (2 screws). My voltmeter told me that the transformer was ok (24 VAC out/ 240 VAC in) but nothing else was getting 24 volts! Eventually, I found the fuse, replaced it and it immediately blew out! Traced the problem to mouse-chewed and shorted 24 VAC control leads out to the Condenser unit. Rewired the wire run with new low voltage wire from the furnace to the condenser unit and PRESTO! It all worked and the next 3 amp fuse held!
Where is the serial number located on a 2004 nordyne gas package heat unit
In the air handler on the circuit board a 5amp fuse.
i have a mobile unit want to buy a nordyne eletric furnace 17kw 57000 btu model e3eb-017 240/1ph
slot # 18 15amp A/C sys
All air conditioning manufactures put the Max Fuse size right on the unit itself. If you can't find it on the unit tag, try looking up the model number online.
where is low side charge port located
right hand trunk wall
Inside the unit under the evaporator coil. The condensate drain line is attached to it.
Philco air conditioning and heat pump units are made by NORDYNE, a company with more than 90 years of experience in heating and cooling. Units made by a major manufacturer are all good; the critical difference is the installation. A good unit can perform poorly if installed incorrectly. Selecting a reputable contractor is just as -- or even more -- important than the brand of equipment.
The flasher unit is located up and behind the fuse box. It is black with a socket that has @ 10 wires into it.
the compressor is on the passenger's side of the motor under the van.
The flasher for turn signals in located on the fuse block. The fuse block is on the bottom of the dash to the right of the steering column.