0
What else can I help you with?
Where is the gas tank drain plug located on a 1985 Honda Prelude?
It Does Not Have A Gas Tank Drain Plug. You Will Have To Siphon The Gas Out. Or Drop The Tank With It In It. GOOD LUCK
Does 1992 Honda Accord gas tank have a drain plug?
Yes it does.
Where do you put transmission fluid in a 1992 Honda Prelude manuel?
in the manuel transmission through the check/fill plug
What are the transmission bolts torqued to on a JDM H22A Honda Prelude engine using the F22 transmission housing?
1997 HONDA PRELUDE 2.2L 4-cyl VIN Code H22A4 TORQUES Oil Drain Plug.....33 ft-lbs Manual Transmission Fill Plug.....33 ft-lbs Drain Plug.....29 ft-lbs
Where is the radiator drain plug on a 1992 Honda Accord ex?
In the down panel from back. Its like a butterfly
How do you replace the ECU on a 1992 Honda Prelude?
the ecu should be under the carpet on the passenger side. unplug the old one and plug in the new!
Is there a drain plug on the gas tank of a 1998 Honda prelude?
If you are changing the fuel pump, look for an access panel above the pump. Most Honda's have one and removing the fuel tank is not necessary.
Service plug on 1992 Honda Prelude?
It's a two pin blue plug that resides behind your radio. You have to reach around the back of the black plastic center console.
Diagnostic plug on 1992 Honda Prelude?
It's a two pin blue plug that resides behind your radio. You have to reach around the back of the black plastic center console.
Where is automatic transmission drain plug on 2002 Honda Accord?
There is no drain plug.
Is there a drain plug on a 2000 Honda Accord gas tank is there a drain plug on a 2000 Honda Accord gas tank?
No
Where is Coolant drain on an 88 Honda Prelude?
On a 1988 Honda Prelude, the coolant drain is typically located at the bottom of the radiator. Look for a petcock or drain valve on the lower right or left side of the radiator, which can be opened to allow coolant to drain out. Additionally, you may also need to drain the engine block, which can be done via a drain plug located on the engine block itself, usually at the lower part of the engine. Always ensure the engine is cool before attempting to drain the coolant.
