1997 Honda PRELUDE 2.2L 4-cyl VIN Code H22A4 TORQUES Oil Drain Plug.....33 ft-lbs Manual Transmission Fill Plug.....33 ft-lbs Drain Plug.....29 ft-lbs
Provided they both share an h22a or f22a engine they should be a perfect match!
The transmission housing for a 1991 E350 is bolted to the rear of the engine. The entire transmission case is considered the housing.
The bell housing is the front of the transmission, the end that bolts to the engine.The bell housing is the front of the transmission, the end that bolts to the engine.
Yes. The H22a and H23a motors can interchange transmissions.
how to make base prelude h22a engine on type sh 5 speed trans ^^^??? to answer the question. yes a sh transmission with "atts" unit will fit a base prelude (if a h22 motor is used) is it worth it? absolutely not
The bell housing is the front of the transmission ( the larger diameter portion ) where the transmission is bolted to the engine
The bell housing is between the engine and the transmission.
between the transmission and the transmission housing
In theory, if you can find a transmission housing, flywheel, and clutch that will attach to this engine.
The transmission is located in close proximity to the engine, usually (in Hyundai's) transversely mounted directly under and behind the engine (behind the engine in terms of: following from the front of the vehicle towards the rear of the vehicle). If you follow the transmission fluid dipstick housing (shaft) down - that transmission fluid dipstick housing will end directly into the upper-most part of the transmission housing.
The 1999 Sentra starter is located right beside the transmission bell housing. That is the housing where the transmission bolts up to the engine.
The outfit where you are getting your engine should know if the transmission housing will bolt up to the engine.