how to make base prelude h22a engine on type sh 5 speed trans
^^^???
to answer the question. yes a sh transmission with "atts" unit will fit a base prelude (if a h22 motor is used)
is it worth it? absolutely not
Provided they both share an h22a or f22a engine they should be a perfect match!
Provided the '97 Prelude is a base model, then yes it is possible to swap in an H22a variant. The Prelude Type SH motor is different as the ATTS unit is connected to the motor. So, the only compatible H22a motors would be one from another Type SH, or the JDM Honda Prelude Type S motor.
Yes. The H22a and H23a motors can interchange transmissions.
The 97 Honda Prelude motor (h22a) will fit into a 2000 civic with custom mounts (available to purchase online), however you will need the h22a transmission, shift-linkage, axles, and ecu (full swap). The h22a motor will not work with the stock d-series transmission.
Transmission Dipstick should be on the left down the bottom, it is quite hard to get to so don't attempt to reach it when your car is hot! The transmission dipstick should have a yellow handle, i have a 93 h22a Honda prelude and mine is on the drivers side right down the bottom you have to look for it quite hard, look for a yellow handle. Hope this helps.
This conversion is to put a h22a engine from the 4-5 generation Preludes to the 3rd generatio Prelude, this conversion is very much so do-able, but. Their are issues with clearance of the sump of the h22a in the 89 Prelude. New engine mounts need to be used, new ECU needs to be installs aswell. Also you will have to use the gearbox from the h22a. Can't use the old gearbox in your 89 Prelude. It's a big job but there are plenty of examples of great Preludes sporting the newer engines.
H22A Honda engine it ready for a turbo
1997 HONDA PRELUDE 2.2L 4-cyl VIN Code H22A4 TORQUES Oil Drain Plug.....33 ft-lbs Manual Transmission Fill Plug.....33 ft-lbs Drain Plug.....29 ft-lbs
You Can perform an engine swap to a h22a manual or a b16 manual. You will get more power with the h22a but the motor cost money.
Max rpm / redline (often they are actually different) is not based on the car but on the engine. Prelude S (F22A1 engine) max rpm: 6250-ish Prelude VTEC (H22A engine) Redline: 7200/7600 rpm Max rpm: 7400/8000 rpm Preludes from 92- were delivered with the following engine options F20A, F22A, H23A, H22A.
to answer your question is has endless possibiltys but i would say the best is h22a prelude engine
Yes the H22 will fit in a 1990 prelude. It is a very tight fit and requires modification. You would need a new transmission, ecu, new wiring, motor mounts, ect. Before you decide to do this swap you need to really think it through. Its very costly, difficult, and can be troublesome. And remember this is all for a 60-65 hp gain.