0
On a 1998 Mercury Mountaineer :
According to the Owner Guide :
( the fuel pump shut off switch / inertia switch is in the front passenger
footwell behind the kick panel )
* the kick panel is the interior trim panel , just in front of the front door , beside the persons feet
What else can I help you with?
Where is the fuel reset button on a 1998 mercury mountaineer?
In the front passenger footwell , behind the kick panel
How do you reset the anti theft on a 98 Mercury Mountaineer?
The easiest way to reset the antitheft system in your 1998 Mercury is to remove the antitheft system fuse. Keep the fuse out for 10 seconds and then replace it to its original position.
Does 1998 Mercury Mountaineer 5.0 have a timing belt?
No , the 5.0 liter V8 engine in a 1998 Mercury Mountaineer has ( 1 ) timing CHAIN
Change a mercury mountaineer transfer case?
How do i change the chain out of my 1998 mercury mountaineer transfer case
Does a 1998 mercury mountaineer have overdrive?
Yes
Can you replace just the bulb on a headlight of a 1998 Mercury Mountaineer?
Yes , according to the 1998 Mercury Mountaineer Owner Guide : ( the headlight bulb is # 9007 )
What transmission does a Mercury Mountaineer have?
If you have a 1997 to 1998 Mercury Mountaineer or Ford Explorer with a V8 engine, you will have a 4R70W transmission.
Change front wheel bearing on 1998 mercury mountaineer?
how do you change wheel bearing on 98 mercury mountaineer
Where is the starter located on a 1998 Mercury Mountaineer?
The starter on a 1998 Mercury Mountaineer is located on the passenger side of the engine. It is down low, almost underneath the motor.
Where is the starter located on 1998 mercury mountaineer?
The starter on a 1998 Mercury Mountaineer is located on the passenger side of the engine. It is down low, almost underneath the motor.
Where is the fuel pump shutoff switch for a 1998 mercury mountaineer?
where is the fuel pump shutoff switch for a 1996 mercury mountaineer
How do you set the clock on 1998 mercury mountaineer?
To set the clock on a 1998 Mercury Mountaineer, start by turning the ignition key to the "On" position without starting the engine. Next, locate the "Clock" or "Set" button on the radio or dashboard. Press and hold the "Set" button while using the "Hour" and "Minute" buttons to adjust the time. Release the "Set" button when you're finished, and the new time should be displayed.
