0
What else can I help you with?
In a 1991 Bonneville Can the crankshaftsensor keep the car from starting?
i have a 92 bonn. and my car wasnt starting and it turns out it WAS the crankshaft sensor and the harmonic balancer
Where is the crank sensor located on a 1991 Buick Park Avenue?
It's just behind the harmonic balancer.
Where is the crank sensor in a 1991 Cutlass Supreme?
Behind the harmonic balancer (dampner) that is located behind the crankshaft pulley.
How do you change harmonic balancer on 1991 buick lesabre?
The flywheel has to be held in place by a holding tool, Remove the mounting bolt, then use a balancer remover to pull the harmonic balancer.
My 1991 dodge stealth twin turbo its leaking water from around the harmonic balancer?
more than likely it is leaking out of the weep hole located at the bottom of the water pump and is running down to the harmonic balancer,if so your water pump is on its way out
Where are the timing marks on a 3.1 1991 Chevy Beretta?
On a 1991 Chevy Beretta with a 3.1L engine, the timing marks are located on the harmonic balancer and the timing cover. The harmonic balancer has a series of notches, while the timing cover has a pointer that indicates the correct timing. To set the timing, align the mark on the harmonic balancer with the pointer on the timing cover at the specified timing degrees. Always refer to the vehicle's service manual for specific timing specifications and procedures.
Where is the crankshaft sensor located on a 1991 Buick LeSabre custom?
to my knowledge it is located behind the harmonic balancer. You should be able to c the wires runing to it just to the right of the harmonic balancer. Now if you could help me with information on how to uninstall the harmonic balancer i would greatly appreciate it Thanks. To remove the harmonic balancer you have to buy or rent a harmonic bancer puller. The bolts required for yours may not be included. If not you will have to go to the hardware store and purchace them. You should use the 3 1/2 inch #8 1/4 inch bolt 3 required also buy 3 washers cost under 4 dollars.
Where is the crank sensor on 1991 olds cutlass ciera?
the crank sensor is behind the harmonic balancer
Timming marks for 190se 1991 6cyl?
Timimg marks are on the harmonic balancer and pointer is on the lower timing cover
Is it normal to have weight added to the front of a 1991 350 crank to get it balanced?
the harmonic balancer, is the pulley on the front of the crankshaft. this is used to balance a crankshaft.
How is the front Main Seal changed on a 1991 Jeep Laredo 4.0 Liter?
Remove the serpentine belt. Remove the harmonic balancer. Pry it off the crankshaft. Install new seal, replace balancer and belt.
Where are the ignition timing marks on a 1991 190E 4 cylinder you don't see a harmonic balancer Thanks?
there is only one mark and one pointer
