If you look from the engine compartment you will see the 2 heater hoses that
connect to your heater core at the firewall towards the passenger side
On my 1995 Ford Explorer with 4.0 L OHV engine , where the heater hoses are connected right at the firewall , the hose nearest the driver's side is the supply hose to the heater core , and the hose nearest the pasenger side is the outlet from the heater core. (Helpfull)
Instualation of a heater core on a 1999 Ford Explorer V6, how do you install the heater core.
see the answer for how do you replace heater core 96 jetta its the same good luck and god speed
Disconnect the heater hose off the heater core on the firewall and remove the inside middle side panels along with the lower heater core panel and pull the core straight out.........
On a 1996 Ford Explorer : The blend door would be INSIDE the plastic case that has the heater core ( and air conditioning evaporator if equipped with A/C ) located below the glove compartment
Thermostat and/or heater core may be defective
Check the heater core, it is probably bad. It could be heater hose connections to the heater core, but I would bet on the heater core going bad.
Basically behind and below the glove compartment , you can see where the heater hoses connect to the heater core at the firewall from the engine compartment
The heater core can be found behind the passenger side kick plate. Remove the water supply hoses from your 1996 Chevy Impala heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
specs on how to replace a heatercore on a 1993 ford explorer
It should be the same as my 1995 - at the firewall the heater hose nearest the drivers side is the inlet hose to the heater core
Answer replacing the heater core on a 1991 explorer is a simple job and takes around 30 minutes. disconnect the hoses from core in engine bay. remove access cover located below the dash on passenger side. remove core, replace core.