Instualation of a heater core on a 1999 Ford Explorer V6, how do you install the heater core.
specs on how to replace a heatercore on a 1993 ford explorer
how to remove the lines from the heater core on a 2001 expedition
You have to take half the car apart to replace the heater core
On my 1995 Ford Explorer with 4.0 L OHV engine , where the heater hoses are connected right at the firewall , the hose nearest the driver's side is the supply hose to the heater core , and the hose nearest the pasenger side is the outlet from the heater core. (Helpfull)
It should be the same as my 1995 - at the firewall the heater hose nearest the drivers side is the inlet hose to the heater core
Heater core is leaking.
I'm not a mechanic / technician but I was looking at fordparts.com and comparing the heater cores for the 1996 Ford Explorer and the 2000 Ford Explorer and they show the same part number ( so apparently the answer would be YES )
could be head gasket problem. does your heater work? might need heater core , clogged up. do compression test. or bypass heater core and see if that works.
Look behind the glove box, up under the dash.
Bolt the heater core into its proper position. There are four retaining bolts. Connect the water lines to the heater core. Fill the cooling system with coolant.
Try looking under the dash just below the heater core box on the right hand side. The switch should be mounted below the heater case. I have a 91 Ford Explorer but the 91 - 94 Explorer's are the same.
i need some illastrations???
LOTS - it is virtually inaccessible .
I just bought my heater core for my 1997 Ford Explorer 4x4 Sport for $60.00(Plus Tax) but I was surfing the web and found that you can order it in line with SPI or STANT from $29.00 to 32.00 plus shipping. Good Luck
your heater core is leaking i would replace it.
Behind / below the glove compartment , inside the plastic box with the heater core
autozone.com has online manuals that give step by step how to
The heater core is like a small radiator - the engine coolant flows through the heater core . The blend door mixes varying amounts of unheated air with the heated air to regulate the temperature
Answer replacing the heater core on a 1991 explorer is a simple job and takes around 30 minutes. disconnect the hoses from core in engine bay. remove access cover located below the dash on passenger side. remove core, replace core.
The heater core is located in the dash ,or should I say in the heater /ac plenum if you chase out the heater hoses from under the hood you'll get a general idea where it is located.
Under the dash board on the passenger side. You can find it easily by looking for two hoses (under the hood) that connect to the heater core right at the firewall.
Follow the heater hoses from the engine, they will lead you the heater core.
Try reverse flushing Disconnect heater hoses and try running a garden hose through in both directions.
How do you replace a heater core in a 1998 ford expedition?"