Want this question answered?
The high oil pressure relief valve is located in the oil pump
high pressure oil pump
In most model years, the high pressure oil pump is located under the intake manifold. Therefore, the first step is removing the intake manifold in order to access the pump. Undo the cover bolts and remove the high pressure oil pump, remove and discard all gaskets, seals and O rings. Replace the lower O ring seal, then the high pressure oil pump and bolts. Install the main oil pressure pump O ring seal, then the discharge pipe and bolts. Tighten all bolts to factory specifications. Install a new D ring seal on the discharge pipe and a new gasket on the oil pressure pump cover. Then replace the pressure pump cover and bolts.
It is built into the oil pump/ Part of the oil pump.
check out www.powerstroke.org/forum/6-0 motor-problems/67527-high-pressure-oil-pump-04 high pressure oil pump 04 6.0 ford powerstroke diesel forum
the high pressure oil pump supplies the oil to the rails mounted over the injectors in the valve covers and there is two sensors that control the pressure ipr and ipc located on pass side valve cover the ipr is behind the turbo in the high pressure pump cover
Which one they have 2. A low side pump which is behind the front crank dampener and a High Pressure oil pump which is located under the fuel filter housing in the valley. Hope this helps. Powerstroke57
the high pressure oil pump
it is located inside of the oil pan. if you have low pressure and have high milage you could have bad crank bearing.
The oil pressure switch on a 1997 Chevy Blazer is located on the bottom of the engine, near the oil filter. It monitors the output and pressure of the oil pump.
What steps are needed to change a high pressure oil pump ona 03 6.0
how do you replace a fitting from a high pressure oil pump that is leaking oil in a 2001 ford F350 diesel truck?