waste of time
its located behind the front bumper by the passenger side headlight
It is important to know where the parts are within a car. The horn relay in a 1993 Mazda Protege is found in the cars fuse box.
The 1993 Mazda the inertia?æswitch can be found on the firewall in the engine compartment. The inertia switch will be on the passenger side of the firewall.
The idle air control valve is on the the bottom of the throttle body.
I haven't been able to find.
A 1993 Mazda MX-3 does not have an inertia switch. If anything is wrong with what would normally be the inertia switch, the fuel pump may be faulty.
just beside the radiator under the front bumper, so on the driver side for a LHD car.
The fuel pressure regulator is located on the fuel rail of the vehicle.
in engine bay fuse board
ckeck for vac. leak at brake booster
What causes my Mazda mx3 to turn off while driving down the road.
What are the head bolt torque specs for a mazda mx3 1600
behind the front bumper on the chassis.
Mazda has a recall on their seatbelts for some models for this reason. ask a Mazda dealer if your model has the seatbelt recall. I believe the 92 mx3 has a recall for the auto seatbelts, but i am not sure about 93. Look into it though and they might fix it for free!
The Mazda MX3 was first produced in 1991. It was introduced at the Geneva Motor Show in March of 1991. The MX3 was produced until 1998, when production was halted.
The neutral safety switch, release switch, or brake switch is bad.
I have a 1993 Mazda Protege LX and I was told that there is no relay for the horn, there is a horn switch inside your steering wheel. that might help
Under the intake manifold. The starter is connected to the bell housing on the transmission and is held on by three bolts.
yes, you will have to remove all the plastics from the 94 and put them into the 92, as well as the wiring.
if it is a 5speed it does not take trannsimission fluid it take cluth fluid
heater core leaking
because is reeving, there for it depends on the amount of pressure you apply to the gas
This is done the same as the 1995 Mazda MX6. The answer is posted.