answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where is the horn relay located on a 1988 Chrysler 5th Avenue?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the turn signal relay located in 1988 Buick Park Avenue?

The relay is usually in the engine compartment of the fuse box. Open the fuse box cover can be found according to the identification


Where do you pour the power steering fluid in a 1988 Chrysler 5th avenue?

In the power steering pump located on the front right side of the engine. It will have a pulley on it


What car does mike the mechanic drive on Breaking Bad?

A 1988 Chrysler Fifth Avenue


Where is the 02 sensor on a 1988 Chrysler Fifth Avenue?

drivers side exhaust manifold...


Where is the blower motor relay on a 1988 Buick Electra park avenue?

it is behind the glove box


Where is the fuel pump relay located in a 1988 Honda prelude?

where is the fuel pump cutoff relay located in a honda 88 prelude?


Where is the turn signal relay located and how do you replace it located on a 1988 Toyota Camry?

it is in taylorville


What is the firing order for a 1988 Chrysler Fifth Avenue?

The correct firing order for the 318 cu. in. Chrysler engine is 1-8-4-3-6-5-7-2.


Where is the fuel pump located on a 1988 Chrysler new yorker?

the fuel pump is located in the gas tank


Where is an 1988 Mazda 626 fuel pump relay located?

On a 1988 Mazda 626, the fuel pump relay is located in the fuel tank. Always disconnect the battery before beginning work on a fuel system.


How do you change the front speakers in a 1988 Chrysler Fifth Avenue These are located on the top of the dash?

You have to pull the entire dashboard. I have done it and it gets easier every time. Get the Haynes/Chilton manual and it will tell you how. Get the proper speakers and it is a afternoon job.


How do you get to the front dash board speaker in a 1988 Chrysler Fifth Avenue?

You have to remove the whole dashboard and then the speaker should be exposed, then just remove it.