Yes you can I have 1988 Honda prelude with the 2.0L in it.
The oxygen sensor on a 1988 Honda Prelude fuel injected engine is on the exhaust manifold. It screws directly onto the front of the exhaust manifold.
the oil filter is located on the back side of the block in the middle
my 1988 4ws Honda prelude idles low at 600 rpm
Yes, the 1988 and 1989 Honda Prelude has a VSS that is a cable sending unit that connects to the gauge cluster in the dash.
None of the dashboard lights work on my 1988 Prelude. Why?
Location of the Main Relay SwitchThe main relay is located under the drivers side dash panel, behind the fuse panel. There are four Phillips head screws holding the dash panel on and one 10 mm screw holding the main relay in. The main relay is usually marked MITSUBA or something similar and is about 3" X 1.5"
Screwed into the head.
under left hand head light
It is your main relay. Its under your dashboard on the driver side. it is hard to see. its on the left side of the fuse box you might have to unscrew it.
The throttle body diagram for the 1988 Honda Prelude is found in the maintenance manual of this car. It can be obtained as a print out from an automotive store as well.
The 88 Prelude does not use a dual timing belt. It has a single timing belt
Yes. All Preludes do.
The fuse for the heater and the CD player in Honda Prelude 1988 can be found using?æa fuse diagram. The diagram is available online and can be found by looking for '1998 prelude fuse panel diagram' on any search engine.
It should be under the dash and takes 5 mins to swap out, matushita RZ-XXXX it is called the "main relay" which does both the fuel pump and ignition. Assuming this is fuel injected. Just replaced mine in my 86 Si and it fixed problems with the pump not coming on all the time when starting. $70 from the dealer.
I just went through that exact problem with my 88 prelude, it was the ignition cylinder.
fuel pump cut off relay is located under the dash on the drivers side, pluged into the back of the fuse panel. it is gray in color with a metal back that is vented
Hey they usually come with a 2.0 litre b20a motor
Yes it will fit, all of the twin cam third gen preludes 1988-1991 have the same motor config. You can even put the fourth gen vtec prelude motors in the third gen chassis with mount kits.
The relay is a small plastic box ( 3'x1.5') is the only one of grey color. I located on the fuse box..under the steering column.
Yes, with some custom mounts for the engine and transmission. This can be expensive if you have a shop do the work for you.
if its a 2.0 then 2.0 liters of oil! 2.0 is the engine size, a 1988 Honda prelude 2.0 holds exactly 4 quarts of oil, i just changed my oil today and it says that in the owners manual.
The answer is no. The fuel-injected engine from your 1987 Accord is a direct-fit into a 1985-1987 Prelude Si, but will not fit into a 1988 or newer Prelude due to a completely different engine and transmission being used. The wiring harnesses and ECU will also be very different.
Most of them just drive out. Get the new ones and you will see how they install.
20 inches on the driver's side, 19 inches on the passenger side.