The oxygen sensor on a 1988 Honda Prelude fuel injected engine is on the exhaust manifold. It screws directly onto the front of the exhaust manifold.
An oxygen sensor is a device that measures the oxygen in a car's exhaust. The computer uses this to adjust the amount and timing of fuel injected.
The computer uses the oxygen sensor reading from the exhaust to adjust the amount of fuel injected into the engine.
The cylinder position sensor is located in the distributor.
Oxygen sensor or lambda sensor is situated in the exhaust pipe in front of the catalyst. Disconnect from loom and unscrew with large spanner.
The IAT sensor on the 1993 Honda Prelude is located to the right of the intake manifold as you face the engine compartment. It is connected with red and green wiring.
The O2 sensor on a Honda Prelude is found on the exhaust pipes of the vehicle. They are located near the catalytic converter which is place on the underside of the chassis.
Oxygen sensor is located at the exhuast Manifold.
under the distributor!
The front oxygen sensor is located on the exhaust manifold of the BMW 318ti. The rear oxygen sensor is located in the head pipe.
The upstream heated oxygen sensor is located ahead of the catalytic converter The downstream heated oxygen sensor is located behind the converter
The upstream heated oxygen sensor is located ahead of the catalytic converter The downstream heated oxygen sensor is located behind the converter
The upstream heated oxygen sensor is located ahead of the catalytic converter The downstream heated oxygen sensor is located behind the converter