Yes you can I have 1988 Honda prelude with the 2.0L in it.
my 1988 4ws Honda prelude idles low at 600 rpm
how do you adjust the timing on a 1988 honda xr200
Most of them just drive out. Get the new ones and you will see how they install.
Yes, the 1988 and 1989 Honda Prelude has a VSS that is a cable sending unit that connects to the gauge cluster in the dash.
where is the fuel pump cutoff relay located in a honda 88 prelude?
None of the dashboard lights work on my 1988 Prelude. Why?
Screwed into the head.
The oxygen sensor on a 1988 Honda Prelude fuel injected engine is on the exhaust manifold. It screws directly onto the front of the exhaust manifold.
under left hand head light
Yes. All Preludes do.
On the driver's side of the engine under the timing belt cover. It is driven by the the timing belt. If you do change it you should always replace your timing belt and water pump while you are in there. You will save yourself time and money in the long run.
The throttle body diagram for the 1988 Honda Prelude is found in the maintenance manual of this car. It can be obtained as a print out from an automotive store as well.
The fuse for the heater and the CD player in Honda Prelude 1988 can be found using?æa fuse diagram. The diagram is available online and can be found by looking for '1998 prelude fuse panel diagram' on any search engine.
I just went through that exact problem with my 88 prelude, it was the ignition cylinder.
Hey they usually come with a 2.0 litre b20a motor
Actually 'set' the timing or advance/retard the timing? Adjusting the timing is as simple as moving the distributor forward or reverse on its 'set' bolt, this is advancing or retarding the timing away/toward TDC (top dead center). Setting timing involves a timing light and positioning the light against crankshaft markings through a viewing window located under the distrib.
Yes it will fit, all of the twin cam third gen preludes 1988-1991 have the same motor config. You can even put the fourth gen vtec prelude motors in the third gen chassis with mount kits.
the oil filter is located on the back side of the block in the middle
Yes, with some custom mounts for the engine and transmission. This can be expensive if you have a shop do the work for you.
Yes u can
If its a 4 wheelsteer model look towards centre of the car.
20 inches on the driver's side, 19 inches on the passenger side.
if its a 2.0 then 2.0 liters of oil! 2.0 is the engine size, a 1988 Honda prelude 2.0 holds exactly 4 quarts of oil, i just changed my oil today and it says that in the owners manual.
A complete air conditioning system install on a 1988 Honda CRX has the potential to costs thousands. Everything would have to be safely installed and checked to make sure it is street legal. A bad install can lead to poisoning the community.