0
It is the same as the brake reservoir. You should see a line heading from that to the clutch master cylinder. Cheers.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Is the clutch in an 1987 ford F150 hydraulic or not?
Yes,
Can you adjust a clutch on 1987 Honda shadow 1100?
If there is a hydraulic master cylinder at the clutch lever (looks like the front brake) then...NO.
Why is the clutch pedal of your 1987 Honda Accord so heavy?
Low of hydraulic fluid. Check the reservoir.
Does 1987 Comanche jeep truck use clutch grease?
I don't know what you mean by clutch grease, but the clutch master cylinder uses dot 3 brake fluid as a hydraulic.
How do you disconnect the hydraulic clutch on a 1987 Ford Ranger?
on the side of the transmission where the hydraulic clutch line goes in the trans there will be a white clip on the line push in toward trans with flat screw driver and it should just pop out that's after its pushed in all the way
What if your 1987 Chevy s10 clutch is not engaging how can you fix that?
If the clutch was not disengaging I would say the clutch master is empty of hydraulic fluid, this would be a result of a leak in the master or the slave cylinder. If the clutch is not engaging I would suspect the clutch disc has shredded in which case the clucth assembly would have to be replaced.
Do you need to maintain fluid in a 1987 Honda Accord clutch?
Yes you do. The vehicles clutch works by hydrolic pressure. there must be fluid in the lines and reservior so that when you press the clutch pedal it has enough force to separate the pressure plates. Watch for the clutch fluid levels, usually they stay pretty constant, but if it has a leak you will notice the fluid level will be low. KeVin Toronto
Were do you add trans fluid to a 1987 mustang gt?
Into the transmission fluid reservior
How do you install a clutch cable on an 1987 1500 4x4 GMC truck?
Last time I checked there was NO "Clutch Cable" it is a Hydraulic System. Good Luck and Remember.Change Your Mind, Not Your Oil.Use the First In Synthetic Motor Oil's.See My Bio For more information.
How do you adjust or replace a clutch in a 1987 ford ranger?
if it is a self-adjusting clutch, you can't adjust it. if the cluth engages at the top, then you will need a new clutch. just take it to a ford dealership, its the easiest way to get it done right because of the hydraulic cylinders and what not also you could try bleeding the air of of the lines
What is 1987 Volvo spark plug gap?
The recommended spark plug gap for a 1987 Volvo (all models) is .028"
Where is the clutch safety switch on a 1987 Nissan Pickup?
on your clutch pedal
