twist the top of the choke, there is no idle screw on the 1999 yz250
There are two screws on the carb the top one goes 1.5 turns from all the way in unless it is bored out and the lower screw is used to adjust the idle speed a 2storke should barley Idle when warmed up all the way.
it probably wont line up correctly with the top end
The gas tank on a 1999 Yamaha YZ 250 has a 3-gallon capacity. The YZ250 has a 244 cc liquid-cooled two-stroke reed-valved engine.
According to the manual it is 1.27 us quarts
Carb. idle screws are set so thew vehicle idles they are not set at a specific number of turns. With the screw turned out but still in the carb start the vehicle. Let it warm up then turn the screw in until the engine will just idle. There are other adjustments that may assist are to the pilot fuel/air screw. This should be screwed all the way in until it lightly bottoms then turned out 2 turns to start. Once the bike is idling per above turning this screw until it idles at the highest point. This should be between 2 and 3 turns out. Readjust the idle screw to the lower idle if needed and you will be ready to go.
Yes, a YZ 250 is a 2 stroke, a YZ 250F is a 4 stroke.
NO
2001-2012
with a little snipping there should be no problem. if you don't mind doing a little hand work. it's possible because i slapped 1999 yz 250 plastics on my 1990 yz 125.
how do you change a water pump on a 1985 Yamaha yz 250
Anything from 1998 to 2005 should work
Want is the engine oil capacity for a 2000 Yamaha yz 250.