answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2010-04-14 04:18:55

under the distributer cap

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Related Questions


where is the ignition control module loacted on a 1997 chevy cavalier


How do you change the ignition control module in a 1988 Chevy Silverado 5.7L


Where is the control module located on the 1983 Chevy blazer


Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.


The ignition module is located in the distributor, under the distributor cap.


The 1990 Chevy Celebrity engine is distributorless, the ignition is handled by a combination of the engine control module(computer) and the ignition control module. You did not mention which engine the car has. If your car has the 4 cylinder engine the ignition control module is below the intake manifold at the rear of the engine. You can follow the spark plug wires to it. The coils are mounted to the ignition control module. If your car has the V6 the ignition control module is near the starter and again you can follow the spark plug wires to it. Again the coils are mounted to the ignition control module.


Have you checked the ignition control module? Have you checked the ignition control module?



The ignition module is located under the coil pack. Follow the spark plug wires to find the coil.


All 1987 to 1990 Chevy Celebrity engines use distributorless ignition. Timing is controlled by the engine control module in conjunction with the ignition module. There is no provision for adjustment.



The ignition control module is located under the electronic ignition control module cover. On a 1997 2.4L cavalier, it will have the words 2.4L twin cam stamped on it. It is on the top of the engine and is held in place with four bolts. This cover must be removed to get to the spark plugs.


On the V6 the ignition module is under the distributor cap.


by the EGR valve on passenger side of engine


The coils are bolted to the ignition control module, there is no coil wire as such.


I would replace the ignition control module that's in the distributor.


on the drivers side just under the exhaust manifold


I would suspect a failing ignition control module.


Depending on what type engine you have, the ignition module may be an integral part of the distributor cap.


The 1999 Chevy S 10 pickup truck ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.


You can replace the ignition control module and the crankshaft position sensor as required.


It will not run if you bypass the ignition module (no spark).


its located on driver side head on top of block little black module with plugwire running out of it


On the 96 Tahoe, 5.7L V8 the ignition control module is on a plate in front of the distributor on the passenger side of the engine. It is next to the coil pack. Original Answer: It is in the dist. remove cap and you will see it.


The 1992 Chevrolet Corsica ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.



Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.