The ignition module on a 86 ciara 2.5 is located under hood, center,lower engine area,below driver side of intake manifold . mounted inside of distributor
underneath the ignition coils
Under the coilpacks
under the coils
Is the Claias 2.3L 2.5L or 3300?
the ignition control module is operated by the pcm,the pcm tells the ignition control module when to energize the coils to enable spark
The 1994 Ford Aerostar ignition control module is located on the firewall in the engine compartment. The ignition control module will be on the drivers side of the firewall.
Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.
You can find the Ford Focus ignition control module beneath the drivers side dashboard. The ignition control module will be above the accelerator pedal.
The ignition control module sit directly below the distributor.
Where is the ignition control module located in my 1992 Crown Victoria
Code 42 on an Oldsmobile Cutlass Ciera means you have a faulty ignition control module. You should inspect all electrical connectors to ensure they are tight.
ignition control module is under the distributor cap
Where is ignition control module on a 2001 mercury sable
Only the EEC-IV ignition systems ( 1991 to 1995) use an external ICM (ignition control module) . From 1996 on with the EEC-V system the ignition control module is incorperated into the power control module (PCM) mounted in your firewall on the passenger side.
A Mercedes-Benz 300SE ignition control module can be obtained from most Mercedes-Benz dealerships. The ignition control module, can be purchased at most auto-parts stores.
The ignition switch is part of the WCM (wireless control module).The ignition switch is part of the WCM (wireless control module).
where is the ignition control module loacted on a 1997 chevy cavalier
The 1990 Chevy Celebrity engine is distributorless, the ignition is handled by a combination of the engine control module(computer) and the ignition control module. You did not mention which engine the car has. If your car has the 4 cylinder engine the ignition control module is below the intake manifold at the rear of the engine. You can follow the spark plug wires to it. The coils are mounted to the ignition control module. If your car has the V6 the ignition control module is near the starter and again you can follow the spark plug wires to it. Again the coils are mounted to the ignition control module.
Is located under the coil packs
Disconnect the battery. Remove the ignition coils. Remove the ignition control module that was under the coils, and replace it.
where is the ignition control module on a 1995 Pontiac Transport and how do i replace it
there is no ignition control module on the 1996 model its all through the PCM
The Ignition Control Module on the 4 cyl models is located under the Distributor cap.
1994 was the last year the Ranger used an ignition control module on the 2.3 and 2.5. The ignition control module was attached to the lower intake manifold.
There is not a stand-alone ignition control module in the Windstars.Ignition control is fully handled by the Powertrain Control Moduel (PCM).See "Related Questions" below for more