try under the front passenger seat
The ignition module should be attached to the distributor with two small machine screws.
I AM TRYING TO REPLACE A RACK AND PINION IN A 1997 FORD EXPLORER COULD YOU TELL ME OR GIVE ME A PICTURE ON HOW THE OLD ONE COMES OUT>
There are several things that can cause your 1996 Ford Explorer to stall in start hard. The most common cause is a fuel pump that is going bad.
do you have gas in the tank
key wont turnthe ignition
I believe under the distributor . It should have a plug attached to it.
Type your answer here... How do you remove ignition switch from 1992 ford explorer?
On a 1996 Ford Explorer : ( r134a )
the ignition modular is on the driver side 6" from firewall
On a 1996 Ford Explorer : Yes , the 5.0 liter ( 302 cubic inch ) V8 engine has ( 8 spark plug wires ) with ( 2 ignition coil packs )
No , the 4.0 L V6 engine in a 1996 Ford Explorer is an OHV not a SOHC
how do you manually close a sunroof in a 1996 ford explorer.
Where is the tensioner located on a 1996 Ford Explorer V6 XLT?
The ignition module should be attached to the distributor with two small machine screws.
The transmissions from 1991 - 1994 are the same. So the 1991 transmission will not fit a 1996 explorer.
21 U.S. gallons ( 79.5 liters ) for the 1996 Ford Explorer 4 door
ok