Chevy Celebrity

Where is the ignition module on a 1988 Chevy Celebrity 2.5?

345

Top Answer
User Avatar
Wiki User
Answered
2012-02-29 08:01:06
2012-02-29 08:01:06

The ignition module on a 1988 Chevy Celebrity with 2.5 engine is on the side of the block beneath the intake manifold. You can simply follow the spark plug wires to it. As information the crankshaft position sensor is behind the ignition module.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


The 1988 Chevy Celebrity uses distributorless ignition. There is no provision to alter timing, the engine control module takes care of that.


How do you change the ignition control module in a 1988 Chevy Silverado 5.7L


module locatedwhere is the module on a 9 Chevy blazer


where is the ignition module located on a 1988 Mazda b2200


what is the wiring diagram for an 1988 Chevy celebrity stero


The 1988 Chevrolet Celebrity uses idistributorless ignition systems, the timing is controlled by the ECM. there is no provision for adjustment.


How do i change the ignition switch in a 1988 Chevy camaro


what is the ignition timing for a 1988 Chevy 454 engine


how do you remove the ignition control module on a 1988 ford f-250 pickup?


What happens depends greatly on which module fails. If the engine control module (computer) fails it may cause the engine to run poorly or not at all. If the ignition module fails the engine won't start.


The starter on a 1988 Chevy Celebrity is located on the bottom of the block at the bellhousing.


The fuel filter in your 1988 Chevy Celebrity is on the driver's side behind the rear wheel next to the fuel tank.


The fuel pump on your 1988 Chevy Celebrity is in the fuel tank.


under neth the coil packs middle back of engine 3 bolts you will need a 10 milimiter 12 milimeter and 13 i did mine 4 TIMES !!!!


In a 1988 Chevy pickup the ECM is located behind the glovebox.


In my personal experience, two common reasons for no spark on a 1988 Chevy Celebrity are: The crankshaft position sensor has failed. The ignition module has failed. There are the usual other possible problems including failed coils or bad spark plug wires Also it is possible that the engine computer has failed.


The ignition amplifier module or power stage is bolted to the left front inner fender near the battery.


The engine computer, ignition module, is behind the battery in the left front fender.



Follow the 2 pin connector from the top of the coil located on the driver side front of the distributor. It should lead to a 2 pin connector, as well as a 4 pin connector. This is the ignition control module.


I am trying to find the 1988 chevy beretta computer module and where is it located?


The fuel filter on a 1988 Chevy celebrity 2.5 litre FI is located right in front of the rear passenger side tire.



The PCV valve on a 1987 - 1990 Chevy Celebrity is in the top center of the valve cover nearest the firewall.


The green wire is the negative and the yellow is the positive. It should be marked pos and neg on the module.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.