Under the dash attached to the steering column.
The 1994 Pontiac Grand Am ignition lock cylinder is held in place by the retaining ring at the top of the cylinder. Remove the retaining ring. Remove the wiring harness from the back of the cylinder.
where can you find a diagram of 1994 pontiac grand am motor?
There is no distributor cap or even a distributor on these engines since the 6 plug wires are connected in pairs directly to 3 coils on top of the ignition control module. This module energizes and "fires" the coils electronically without the need for a distributor. If you suspect ignition problems check plug wires first, then plugs, then the module and coils.
The engine computer (behind the battery) is the ignition module.
How do you do a front-end alignment on a 1994 pontiac grand prix?
am told my ignition module on my SL 500 is faulty where can i replace this and what exactly does it do?
Passenger side of the firewall, the engine computer is the ignition module.Passenger side of the firewall, the engine computer is the ignition module.
The ignition module uses the crank sensor to decide when to spark.
The ignition module and coil are contained inside the distributor and are not serviced as separate parts.
1994 was the last year the Ranger used an ignition control module on the 2.3 and 2.5. The ignition control module was attached to the lower intake manifold.
under the intake manifold. Only way to it is on the back side of motor. You will need a long/thin 10m.m. socket to get it off.
No.