The ignition failure sensor in an 01 Stratus RT is located above the condenser. It is near the ignition coil. ?æ
sensor is located in the ignition housing itself and can not be serviced seperatly from the housing, it must be replaced
Ignition lock cylinder
That sensor is located on the cylinder head, right next to where the ignition coils are bolted to the engine.
The knock sensor on a 2001 Nissan Sentra is located on top of the engine, near the exhaust manifold. It detects abnormalities in the ignition and combustion cycle.
Two wire sensor under the ignition coil, next to the thermostat housing.
It uses a distributorless coil pack and a crankshaft trigger sensor.
1996 and later models-the camshaft position sensor is located on the back of the distributor, drivers side.the loss of the camshaft position sensor signal will not affect the driveability of the vehicle. whoops,that sensor is located in the distributor,the one on the back is the ignition module.
The crankshaft sensor in your 1990 former Roche is located on the front of the engine. The best way to test your crankshaft sensor is to hook the engine to a Dyno tester.
There are dozens of sensor that have to do with engine management and ignition all over the engine.There are dozens of sensor that have to do with engine management and ignition all over the engine.
YesYes
Never heard of an "ignition sensor". Do you mean oxygen sensor, or maybe crank position sensor, or cam position sensor? There is an ignition "module" also... The oxygen sensor is on the exhaust manifold. The crank posiiton sensor is on the backside of the block. The cam position is on each head.