0
You didn't specify an engine, so I'm assuming you have the same 1.9 liter as I have in mine...
If you follow the spark plug wires back to the ignition coils (the opposite end of the plug wires from the spark plugs) the ignition module is underneath those coils, bolted to the transaxle case. By 'underneath' I mean you have to remove the four bolts holding the coils down to get to the ignition module that they are mounted on.
It's about 5 inches square by half an inch thick with a 5 pin wire connector on the bottom edge.
What else can I help you with?
Where is the ingition control module on a 1993 mustang?
in the distrubuter
Do a Body Control Module on a Saturn L200 need to be reset?
Were is the body control module located on 02 Saturn L 200
Where is the Body Control Module located on a 2003 Saturn ION?
Center counsol
Where is the location of the airbag control module on a 2002 Saturn SC2?
The airbag control module in a 2002 Saturn SC2Êis located underneath the center console. It is the yellow connector behind the shifter.
Were is the ingition control module on your 1985 Chevy s-10 2.8?
The ign. control module on a 2.8L s10 is in the distributor. Remove the distributor cap and it is attached to the base of the distributor
Where is the body control module located on a 2002 Saturn sl1?
above the radio under the center panel
Where is the fan control module located on a 2003 L200 Saturn?
it is behind the left head lamp hooked to the battery
How do you fix a 1999 Saturn control module?
Need to know which control module. Body, powertrain, airbag, or ABS?
Where is the abs control module located at on a 1996 Mazda millenia?
body control module located
Where is ingition control module on 1996 suburban?
If you look at the right side of the distributor you will see 2 sets of electric wires that plug into the module. Remove dist. cap and rotor and then the 2 small screews that hold the module inplace.
How do you install an ignition control module on a 2003 Saturn?
To install an ignition control module on a 2003 Saturn, first disconnect the negative battery terminal to ensure safety. Remove any components obstructing access to the ignition control module, typically located on the engine or near the ignition coils. Disconnect the wiring harness from the old module, unbolt it, and replace it with the new module. Finally, reconnect the wiring harness, reassemble any removed components, and reconnect the battery.
Where is the transaxle control module located on a 2006 jeep unlimited rubicon?
The transmission control module and engine control module are one part and are located under the hood.
