0
Where is the injector drive modual located on a 99 f350 powerstroke?
Wiki User
∙ 14y ago
remove the inner wheel well and it will be there
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is an injector drive module?
your big fat bum
What happens when you drive with a bad fuel injector?
When you drive with a bad fuel injector, your engine will often misfire. You might also have a rough idle and increased fuel consumption.
Where is the fuel injector relay box located on a 1989 Dodge Colt Vista 4 wheel drive?
check behind your ash tray or radio, but not positive.
Diesel powerstroke Engine dies when you shift from drive to reverse?
sounds like the auto transmission has a fault
When you drive your sunfire for about an hour the car suddenly dies the power just stops?
this could be due to a bad ignition modual in the disttibutor
Fuel Regulator location on 2002 GM sonoma 4 wheel drive 4.3 liter?
It is located under the upper intake manifold. It is attached to the "spider" (bank of injector poppets).
Loosen belt tension 2006 powerstroke diesel 6.0?
Use a 1/2" drive breaker bar in the tensioner.
Where is the speed sensor on a 96 F250 powerstroke automatic?
On top of your rear axle (pumpkin) just above the drive shaft yolk it has two wires sticking out of it.
Why is your Dodge Caravan 2003 sputtering when you drive it?
Problem in the injectors. Put a can of injector cleaner in the gas and see if it helps.
What is a saturated fuel injector?
A saturated fuel injector is also known as a High Impedance (or High z) fuel injector. The high z injector has a larger ohm draw through the coil (12v-15v) vs. a peak-hold (Low Impedance, Low z) injector, which is 2v-4v. Another difference is the how the injector uses the voltage to open the injector. A high z injector uses the full voltage to open and hold open the injector, therefore it voltage saturated. A low z injector (peak-hold) has a peak of high voltage to open then injector then uses a lower voltage to keep the injector open for the remainder of it's cycle. What this means to you, the low z injectors typically needs a resistor in line to add the necessary resistance to properly drive the system, otherwise the injectors could overheat to fatigue. A high z injector does not need a resistor.
Is it possible to drive a car on the moon?
Actualy The Answer is YES, and nasa already has driven a vehicle on the moon. it was called a lunar modual or MCV. It was an elecricly driven with no petrol needed. TY for asking this Question. AJL :)
Where is Dale Earnhardt Drive located?
Dale Earnhardt Drive is located in Avondale, Arizona.
