Want this question answered?
There is a temp sensor on the water inlet for the PCM, and sending units for the gauge on the side of the heads. Normally part stores don't carry the sending units.
The sensor is located by the catalytic cnverter on the inlet side.
in the carb inlet
The thermostat on a Chevy 2.2 engine should be located under the top hose inlet. The top hose as well as the inlet need to be removed to get to the thermostat.
No it will not, it will just back flush the heater core and clean it out.
inlet manifold about halfway down
It depends on which of them. The one for coolant is located in the water inlet. Ambient temperature sensor is located in the filter box.
1997 s10 4.3 Chevy blazer. what inlet does the freon go in. the one on the aluminum tank where the hose from the compressor goes into it?
The air inlet temperature sensor on a 2004 Jeep Liberty is located on the intake tube. The intake tube is right in front of the throttle body.
There is NO Mass Air Flow sensor. There is an Intake Air Temperature Sensor located in the air box inlet
The air inlet temperature sensor is found inside the intake of a 2005 Hyundai Elantra. More specifically it is located near the air box where the filter is.
The air intake temperature sender is located at the right hand side, back of the engine when looking from the front of the car. It is found screwed into the inlet manifold at the top of the engine. Disconnect wiring and unscrew sensor.