0
Where is the intake air temperature sensor on the MB 500 motor?
Wiki User
∙ 15y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why does the temperature light come on right away on an 03 polaris predator 500?
Bad temp sensor. Bad temp sensor.
Where is the IAT sensor on 2005 Ford 500?
The combined MAF/IAT sensor (6 wire plug) is on the air intake duct just above the air filter.
What is the cost for a new O2 sensor for a 95 maxima?
I have a '96 Maxima. The O2 sensor and the NOX sensor were replaced at the same time. The parts were $400, and the labor was $500 (the intake manifold had to be removed for one of the sensors). TOTAL COST: $900
1997 Nissan ultima knock sensor where is it?
The Knock Sensor is under the Intake Manifold and above the Oil Filter on the Engine Block. using an OHM Meter the sensor resistance should measure from 500 - 620 Kohms Have A Good Day! Gene
On your Honda 500 rubicon the gear position indicator flashes and it will not shift?
First you need to pull the codes from the display,start from there after you count the number of flashes to determine which code it is,angle sensor,speed sensor,shift motor or ecm.
Where is coolant temp sensor on 2004 F150?
in the head passenger side close to the firewall. the intake will have to be remove to change it part $30 labor $250-$500. I did not take the news well ether
Why does your RPM go from 500 to 2000 when idle?
Eratic idle can be caused by a number of factors. Does this happen all the time or when the motor is warm? Often the problem is an intake air leak. This means somewhere behind the Mass Airflow Sensor ( MAF ) extra air is getting into the system and tricking the brains control of the idle. Common causes for this are a cracked Intake Boot ( the rubber thing behind the MAF ) or a leak somewhere in the gaskets under or on the Intake Manifold. Other causes include a faulty Coolant Temperature Sensor, a fuel leak, A clogged Fuel Filter, an intermittent Fuel Pump Relay, an intermittent Main Relay, a leaking Fuel Injector, a faulty Fuel Pressure Regulator ( FPR ), a bad Throttle Position Sensor ( TPS ), a faulty MAF, a bad Oxygen Sensor, a malfunctioning Idle Control Valve ( ICV ), a faulty Engine Control Module ( ECM also called the car's brain) or any of the wiring between these devices.
Where is the knock sensor on a 99 Nissan Quest?
It is behind the intake manifold on the left side of the engine. It will take almost 6 hours to replace this cheesy part ($120) and cost about $500 in labor alone.
How do you get 500 horse power out of a 350 Chevy motor?
buy a blower intake (prefer 6-71). then buy 6-71 blower, and accesories. change your stock intake put on blower and check pulley ratio to reach 500 horse from the horse your now running stock. Might help to change to alum. heads but if you dont run to much boost you will be fine
Will a 85 cr 500 motor fit on a 86 cr 500 frame?
Should fit it's the same generation motor.
What is the density of the motor oil if the motor oil with a mass of 440 g occupies 500 ml?
400/500=0.8g/cc
Where is the knock sensor on 98 Nissan Quest?
The knock sensor on a 1998 Nissan Quest is also located under intake manifold and yes alot of work but can be done in a day. 120 dollar part and 500 labor at garage but for u at home mechanics just a simple side project.
