0
The intake plenum is simply the top of the upper intake manifold, where the throttle body is attached. It is made of black plastic.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where is the pcv valve located on a 1999 mercury villager 3.3 liter?
it is in the back of vavle cover on firewall side. you can't see it unless you remove the intake plenum.
Intake bolt torque specs for 1999 mercury villager?
The 1999 Mercury Milliliter intake bolt torque specifications is 60 pounds per square inch. The intake bolts should be torqued at 30 pound intervals.
Where thermostat 1999 villager?
How do you change the thermostat in 1999 Mercury Villager
Where is the knock sensor located in the 1999 Mercury Villager?
the knock sensor is under intake, must remove intake and it is under two coolant lines.
Will a 2001 mercury villager 3.3 fit in a 1999 mercury villager?
Yes.
How do you change a knock sensor on a 1999 mercury villager?
The knock sensor is under the intake manifold, which has to be removed. This should be left to an experienced mechanic.
How many gallons does the gas tank on a 1999 Mercury Villager Hold?
According to the 1999 Mercury Villager Owner Guide : ( 20.0 US. gallons )
Where is the crankshaft on a 1999 mercury villager 3.3?
In the engine.
Can you put headers on a 1999 mercury villager?
No, no room.
What refrigerant is used in a 1999 Mercury Villager?
134-A
Why do you smell antifreeze from your 1999 mercury villager?
The most likely cause is an intake manifold gasket leak (that is if all the hoses and water pump have been ruled out)
Where is the fuel injector located on a 1999 mercury villager?
There are six fuel injectors that mount into the lower intake manifold. Only three can really be seen normally.
