The Cisco switches I have seen don't have an IP address by default. You have to connect to the switch with a console cable - one that connects to the console port on the switch, and to the serial port on the computer - and do some initial configuration, including the IP address.
The Cisco switches I have seen don't have an IP address by default. You have to connect to the switch with a console cable - one that connects to the console port on the switch, and to the serial port on the computer - and do some initial configuration, including the IP address.
The Cisco switches I have seen don't have an IP address by default. You have to connect to the switch with a console cable - one that connects to the console port on the switch, and to the serial port on the computer - and do some initial configuration, including the IP address.
The Cisco switches I have seen don't have an IP address by default. You have to connect to the switch with a console cable - one that connects to the console port on the switch, and to the serial port on the computer - and do some initial configuration, including the IP address.
The Cisco switches I have seen don't have an IP address by default. You have to connect to the switch with a console cable - one that connects to the console port on the switch, and to the serial port on the computer - and do some initial configuration, including the IP address.
It doesn't necessarily need and IP. Depends on whether it is a managed or unmanaged switch. For instance your switch would need an IP address in order to telnet to it.
The Management IP address will be configured on the Default Management VLAN (vlan1). Make sure to do a "no shutdown" command on the VLAN as for it is placed into the shutdown state when first configured. Also for telnet you will need to configure the Virtual Terminal Lines just as a regular Cisco Router. If more functionality is needed other than Telnet more configuration maybe needed depending on what switch is being used.
Using comminicution and identfaction purpose ip address cisco
A layer 2 switch may need an IP address if the operator wishes to be able to access it without a serial cable. With an IP address, the switch can be access from anywhere with a connection to the network or an Internet connection.
you plan to use the virtual switch manager you plan to connect to the switch via telnet you plan to use SNMP on the switch
You can't assign an ip to a switch but you can add one to the interfaces......... like: for the management vlan (or any other vlan) Switch(config)#int vlan 1 Switch(config-if)#ip address {your ip address} {mask} Switch(config-if)#no shutdown any other port Switch(config)#int <fa, G, S> <interface number i.e. 0/0> Switch(config-if)#ip address {your ip address} {mask} Switch(config-if)#no shutdown and for a default gateway Switch#conf t Switch(config)#ip default-gateway {ip address}
You need to start CMD or COMMAND depending on OS you have, and in the window type telnet and following by IP address of device you want to connect to.
Yes Cisco IOS IP address has a secondary address that allows the network interface to communicate to hosts in different IP sub nets. It allows you to have unlimited number of secondary addresses.
interface mode
The Cisco Power over Ethernet (PoE) switch allows connectivity to ethernet-powered devices including wireless access points, video cameras, and Cisco IP phones.
ip route prefix mask address
CDP Cisco Discovery protocol identifies the IP addresss of neighbor router in a corporate network.