answersLogoWhite

0

What else can I help you with?

Related Questions

Which cisco command configures a static route when correcting an ip routing problem at the network layer?

ip route x.x.x.x y.y.y.y destionation k where: x= IP address y= subnet mask


During which stage of the general troubleshooting process do you document a solution?

Correcting the problem


If you have a computer that cannot communicate on the network You find out that it has been assigned an IPv4 address of 169.254.0.5 with a subnet mask of 255.255.0.0 What is the problem?

If the system (fails to locate) or is not able to communicating with the DHCP server, by default windows 7 TCP/IP client auto configures itself using an address in the 169.254.0.0/16 network range. This allows computers on a small network with no DHCP server to communicate without the need for manual configuration.


A technician installed a network adapter in a computer and wants to test the network connectivity the ping command can only receive a response from local workstations what could be the problem?

If you can connect to other computers on the same network, but you can't connect outside the network, the problem is quite often that the default gateway has not been configured correctly.If you can connect to other computers on the same network, but you can't connect outside the network, the problem is quite often that the default gateway has not been configured correctly.If you can connect to other computers on the same network, but you can't connect outside the network, the problem is quite often that the default gateway has not been configured correctly.If you can connect to other computers on the same network, but you can't connect outside the network, the problem is quite often that the default gateway has not been configured correctly.


The network administrator enters the configuration ssh and telnet connections to the switch the telnet connections fail what is the most likely cause of this problem?

The command is bad configurate.


Which command allows you to view the current routing table as part of isolating a network layer problem for an end system running windows 2000?

route print


What is rectifying?

Rectifying is correcting or solving a problem. For example if your car engine was broken, you would take it to a garage to rectify the the problem.


Which command allows you to view the current IP routing table as part of isolating a network layer problem for an end system running windows 2000?

route print


How does a network administrator use the osi model to isolate a network problem?

the network administrator uses the OSI model to troubleshoot network problem by verifying functionality of each layer, in many cases, troubleshooting the network problem requires the network administrator to isolate at what layer the network problem occurs. network administrators often describe networking problems by layer number, for example, a physical link problem is described as a layer 1 problem; a router problem is a layer 3.


What is remedial?

Remediation is the act or process of correcting a problem (a fault or deficiency).


While troubleshooting a connectivity issue on a host a network administrator issues the ping 127.0.0.1 command The pings are unsuccessful What is most likely the problem?

The TCP/IP stack is not loaded properly


Why do texts get queued?

Its an issue in your phones network, to solve problem you need to consult you phones network. There is no problem with your phone