0
Where would the management IP address be configured on the switch in order to mange a Cisco swicth using Telnet?
The Management IP address will be configured on the Default Management VLAN (vlan1).
Make sure to do a "no shutdown" command on the VLAN as for it is placed into the shutdown state when first configured.
Also for telnet you will need to configure the Virtual Terminal Lines just as a regular Cisco Router.
If more functionality is needed other than Telnet more configuration maybe needed depending on what switch is being used.
What else can I help you with?
What does a swicth bring together?
a switch brings together circuits
Where is the reverse light swicth on 1996 vectra 2.0 auto?
boot
Why won't the interior lights turn off in a Dodge Intrepid?
chech at each door pin swicth and see if any one is rusted check tne interior lite swicth is bad or repace it.
Where is the brake light swicth on a 1998 Toyota tercel?
Underneath the steering column
How can you format your nokia n70?
simultaneously press the *#,green and red key then the swicth
How do you turn a nanopod off?
WHERE IT SAYS OFF PUT THE SWICTH THE OPPSITE WAY
Where is hazard swicth at?
Toys lying around.Plug sockets not covered up.Wet floor.
How do level up a magicarp?
Keep it as your first Pokemon then swicth it out in the begginig of a battle
Where are the filter drier and accumulator located on a 1993 Toyota Celica?
its under the heating swicth
Where is the neutral safety swicth located on a 1998Ford E150 van?
on the drivers side on the trans.
What can you do if a 97 Chevy blazer lights stay on when the door is closed and the engine is off killing battery?
the light swicth in the door is gone bad push it in all the way and let it pop back out if that don't stop the problem get a new swicth
How it decides to route packets from PC A to PC B?
deall what u allready have or swicth to new
