0
the knock sensor is under intake, must remove intake and it is under two coolant lines.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Is crank sensor and knock sensor on 2000 villager same thing?
no, it is not.
What years inner change with a 2000 mercury villager knock sensor?
1999 - 2002.
Donde esta colocado el knock sensor de la mercury villager 2000?
donde esta colocado el knock sensor en una Chevy silverado 2000
What is the function of a knock sensor on a 2000 mercury villager?
the knock sensor monitors preignition,spark knock and sends signal to pcm,pcm responds by adjusting ignition timing and fuel timing until knock is gone.
Show where the knock sensor located?
can you tell me where the knock sensor is located on a 3.3l mercury villager
How do you install a knock sensor in a 1993 mercury villager?
the elictronic control sinsor at on a 93 mercury villager
What does the knock sensor look like on a mercury villager?
This is an image. (below)
How do you change a knock sensor on a 1999 mercury villager?
The knock sensor is under the intake manifold, which has to be removed. This should be left to an experienced mechanic.
What are knock sensor symptoms?
There are no symptoms. The knock sensor is a passive part that does not do anything if it's not activated. Knock sensors codes on the Villager/Quest are usually caused by some other component, not the sensor itself.
Where is the knock sensor located in the 1999 Mercury Villager?
the knock sensor is under intake, must remove intake and it is under two coolant lines.
Location of knock sensor on a 99 Mercury Villager?
It is under the intake manifold.
How do you install the knock sensor in a 2000 Monte Carlo?
Where is the knock sensor on a 2000 monti carlo ss 3.8l
