0
What else can I help you with?
Where is the knock sensor located on a 1996 Oldsmobile aurora?
Where is the Knock Sensor located on a 1996 Oldsmobile Aurora?
Where is the knock sensor at on a 1996 cavalier?
The knock sensor is located on the side of the engine block near the bellhousing
You have replaced the speed sensor and O2 sensor on your 1996 Nissan 200SX After a week or so the check engine light came back on Why does this keep happening?
Could be the knock sensor.
Where is the knock sensor located on a 1996 Toyota Avalon?
under the intake manifold
Where is the knock sensor located on a 1996 Crown Victoria?
It is located on the side of the engine block. If you have a code for a knock sensor and you have a noise in the engine, it will set the code. That does not mean that the sensor is bad. They very rarely give problems.
Where is the location of knock sensor 1996 Chevy S-10?
what part of motor is the knock sensor located on 1996 Chevy S-10 4 cyl. passenger side of engine block
Where is knock sensor located on 1996 GMC Sierra 1500?
The knock sensor is on the starter side of the engine. It is abut half way between front and back.
Where is the starter on a Nissan 200sx 1996 located at?
Where is the starter to a Nissan 200sx
Where is the knock sensor on the 1996 Nissan Altima?
Knock sensorThe knock sensor for a 1996 Nissan Altima is located on the backside of the block above the oil filter.But before you go and change it out, run a tank of the best/hightest rated gas you can find and see if that fixes the problem. On my 1995 the Knock sensor is located under the plenum and intake manifold on top of the middle of the block.
Where is the knock sensor located on a 1996 Chevy Tahoe?
It is screewed into the side of the engine over by the starter.
What is the torque spec's of a knock sensor on a 1996 Nissan 200sx with a 1.6 liter engine?
The torque specification for the knock sensor on a 1996 Nissan 200SX with a 1.6-liter engine is typically around 10 to 15 foot-pounds (13.6 to 20.3 Nm). It's important to use a torque wrench for accurate installation to ensure proper function and avoid damage. Always refer to the vehicle's service manual for the most accurate and specific information.
Where is the knock sensor located on a 1996 Plymouth Voyager?
It is located on the engine block. A knock sensor will very seldom give a problem. It detects engine noises and retards to timing. If you have a code then you need to find the noise and repair it.
