0
it is located under the intake (under the gas injedtors)
is blacl and kaind of round,,
What else can I help you with?
How do you remove knock sensor on 95 Nissan 200sx?
To remove the knock sensor on a 1995 Nissan 200SX, first disconnect the negative battery terminal to prevent electrical issues. Locate the knock sensor on the engine block, typically near the intake manifold. Remove the electrical connector, then use a socket wrench to unscrew the sensor from its mounting. Once removed, you can replace it with a new sensor if needed.
Where is the knock sensor located at in a 1998 Nissan 200sx?
In a 1998 Nissan 200SX, the knock sensor is typically located on the engine block, near the cylinder head. Specifically, it can be found on the underside of the intake manifold, usually on the driver's side. Accessing it may require removing some components, such as the intake manifold, to reach the sensor.
Where is the knock sensor located on a 1996 200SX?
The knock sensor for a 1996 200sx is located on the passenger side of the engine. It is located under the intake manifold.
You have replaced the speed sensor and O2 sensor on your 1996 Nissan 200SX After a week or so the check engine light came back on Why does this keep happening?
Could be the knock sensor.
Where is the knock sensor located on 1997 Nissan 200sx-ser?
it is located under the intake (under the gas injedtors) is blacl and kaind of round,,
What is the torque spec's of a knock sensor on a 1996 Nissan 200sx with a 1.6 liter engine?
The torque specification for the knock sensor on a 1996 Nissan 200SX with a 1.6-liter engine is typically around 10 to 15 foot-pounds (13.6 to 20.3 Nm). It's important to use a torque wrench for accurate installation to ensure proper function and avoid damage. Always refer to the vehicle's service manual for the most accurate and specific information.
Where is a knock sensor located on a 1998 Nissan maxima?
The knock sensor is located below the intake manifold
Where is located knock sensor in a 1999 Nissan maxima?
The knock sensor is located below the intake manifold
Where is the knock sensor located for a 2005 Kia Rio?
knock sensor location
Where is Knock sensor location on 1998 Nissan maxima?
Standing on the driver side, looking under the center intake manifold; you will see a round black object with a 10mm or 12mm bolt in the center, which is the knock sensor.
Where is the starter located on a 1998 Nissan 200sx manual transmission?
I just replaced the starter on my 1998 200sx SE-R. You have to remove the intake manifold, and you will see it right under/behind there. You may as well replace the knock sensor while you are in there. About a 2 hour job altogether.
What is a 1992 Nissan Maxima worth?
i just payed $450 for mine and it has idling issues..searching for knock sensor location now...
