Where is the knock sensor located on a 1999 Subaru Forester?
that the knock sensor does
If somebody knocks on the front door of the Subaru, the KNOCK sensor, sets off the KNOCK Alarm....LOL
The knock sensor is located near the idle air control solenoid valve on a 2001 Subaru Forester. The knock sensor is responsible for sensing vibrations caused by engine knock.
Knock sensor/vibration sensor
the knock sensor in on the drivers side of the block toward the rear, and it's under the intake manifold.
I think, behind the timing cover.
If the knock sensor isn't working, the computer won't be able to tell that anything is wrong. Run a diagnostic code anyway. Sometimes it won't turn on a light if it's just a knock sensor.
I don't think it has a knock sensor ( I know that the 4.0 liter V6 engine in my 1995 Ford Explorer doesn't have a knock sensor )
there is no knock sensor on 4.9l V8 motors
In a 1998 Subaru Legacy, the knock sensor is located on the top of the engine block and to the left of the engine. More specifically, it is under the left rear intake manifold runner.
When is sends a code to the ECM that it is malfunctioning. Usually a PO 325 but the codes are slightly different depending on the model and year. You can get a complete Subaru PO listing if you Google it. If there is no code, your knock sensor is fine.
Could be a bad knock sensor. The ECM may be retarding the timing based on bad input from a faulty knock sensor.
Remove the intercooler first. The knock sensor is located under its loation. But you will have to remove some breather pipes to get to it. You will need a long ratchet.
You can find the knock sensor on the top side of the engine under the intake manifold. It is easiest to find from the driver's side and is at the back of the engine block.
It is underneath the intake manifold. If you look straight down from your throttle body, you will see a sensor with one wire coming out and a bolt going through the middle of it, that is the knock sensor.
on top of the engine under the air box
It is located on the engine block drivers side.
I believe the knock sensor is housed at the top of the oil pump. It should be visibly located under the alternator. It's wire should share the same main cable routing as the oil pressure sending unit which is just above the knock sensor and under the left side of the alternator when standing in front of the car. Nothing posotive here, don't quote me
can anyone help me please Its the sensor directly under the intercooler remove the intercooler and a couple of airpipes and you will get at it easiar.
It doesn't have a knock sensor on the 4.0 L OHV in a 1993 Ranger ( my 1995 Ford Explorer 4.0 L OHV engine doesn't have a knock sensor either )
Under the intake arch on the left side of the engine.
It is threaded into the block, under the intake manifold.