Want this question answered?
The temp blend door is located in the HVAC assembly behind the dash assembly. The dash assembly must be removed to gain access.
the door sensors are part of the door latchinside the door
On the door a few inches below the latch assembly...
Inside the door, on the back of the door latch/lock assembly.
The temperature blend door and actuator is located behind the dash assembly. The dash assembly needs to be removed to gain access to the blend door assembly.
The door ajar switch is located on the backside of the door latch assembly, and is accessed inside the door by removing the door trim panel.
It is located behind the dsah assembly, attached to the HVAC assembly. You need to remove dash to gain access to it.
In the latch mechanism
the door ajar is connected to the door lock mechanism. you will have to take the inner door panel off. there are two Phillips head screws located on the outer edge of door where lock mech. is remove these take out whole assembly note you will have to unplug wires. to reinstall reverse steps
The vin is located on the door jam of the drivers door and look at the bottom corner of the windshield on the drivers side.
Inside the door latches
About the only way I know is to find one in a wrecking yard.