your map sensor is on the left side of the intake manifold next to theiat sensor it would be the one that is more at the corner near the back its all black your map sensor is on the left side of the intake manifold next to the iat sensor it would be the one that is more at the corner near the back its all black
There are two speed sensors on a 1996 Dodge Avenger, an input speed sensor and an output speed sensor. Both are located on the front of the transmission.
There is one at each wheel.
The engine size is needed to answer your question.
The starter relay switch is in the same location on both the 1996 and the 1997 Dodge Avenger. The starter relay switch can be found in the fuse box.
Ask a Loacl. HOW do you remove the dash board on a 1996 dodge avenger
may just be a transmission sensor - $20 part - start there...
on the top of the rear axle
Check your hood alignment sensor for the alarm and the trunk sensor
i have a 96 dodge avenger 2.5 and it keeps blowing my ignition switch. any idea why?
its located in the engine compartment on the firewall kinda by th egr valve
Most of them did have the auto.
You can use the front bumper for a 1996 Chrysler Sebring on a 1996 Dodge Avenger.
The dashboard dude
Dodge does not use inertia or kill switches.
What ball bearing are you referring to?
The fluid is inside the transmission.
were is the camshaft position sensor (cmp) location on a 1996 caprice classic
I had the same problem with a 1996 Dodge Avenger 4-cylinder manual transmission and found out that is was the Idle Air Control Motor is located right underneath the Throttle position sensor. It will run as long as a revved the engine but as soon as I would let go of the gas pedal it would not idle and it would shut-off.
I press my thumb firmly on the steering wheel...
replace it. when they go bad you can't fix them.
on the driver side in front of the wheel/ behind the bumper