Remove the steering column shroud shroud (two Philips screws on the bottom)
Remove multi function switch screws on top (I believe it was a T20 torq head)
If you have tilt steering lower the column and lift the switch out your way.
On the left side is the ignition switch remove the singe screw with a T10 torqs with a whole in the middle
on the wire plug slide the red clip up and press down the clip
A retaining clip holds the ignition switch in place on the back of the ignition cylinder on your 2000 Dodge Ram.
A Dodge Stratus does not have a reset switch.
A 2000 Toyota Camry has an ignition switch fuse location in the main fuse panel. It helps protect the switch and the rest of the ignition system from surges.
See the link for a 2000 location. The 2001 procedure ought to be about the same.
How do you replace the ignition switch on a 2000 ford expedition?
Dodge does not use inertia/reset switches.
where is the ignition module located in my 2000 dodge 1500 ram van
Can anyone please tell me where the ignition switch is located on a 2000 oldsmobile silhouette?
Remove the ignition switch retaining ring. Pull the ignition switch out. Remove the wiring harness from the back of the ignition switch. Reverse the process to install the new ignition switch.
The engine temperature sensor is under the alternator.
my brother has a 2001 stratus and had problems with the ingnition switch turning forward. we hired a lock smith to repair it at a fraction of the cost.
There is none as your Dodge is not equipped with an inertia switch.